Pace-edwards SWITCHBLADE Ford Superduty User Manual Page 2

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 1
Read the instructions carefully before you start. If you have questions regarding the installation please visit our
website www.paceedwards.com or call our Technical Support Line at (800) 338-3697.
DRAIN HOLE LOCATIONS:
The Switchblade is designed to carry rainwater from the cover into
the canister and then out through the drains. Most truck models
have standard OE drain holes or plastic/rubber access ports in the
front of the truck bed. Check to make sure your truck has the OE
drain holes so that drilling into the sheet metal is not required. If
drilling is necessary, be sure to check the underside of the truck bed
for the best location. The holes should be located near the side and
as far forward as possible. Use a drill bit suitable for sheet metal
(such as a taper drill or step drill). Drill drain tube clearance holes at
3/4” (19mm). This will need to be done before installing the cover.
FIG. 1
Drain Tube Holes
SWITCHBLADE
®
SERIES
Note: There should be no drilling into the truck body needed on most standard or full-size trucks .
PACKAGING CONTENTS:
Rails (Left
and Right) - In
separate Rail
Box box
Hardware Pack
Clamp Pack
Drain Tubes
Complete Canister
Assembly
Top Cover
TO AVOID SCRATCHING THE SURFACE OF THE RAILS, DO NOT SLIDE THEM
OUT THE END OF THE BOX. OPEN THE BOX ALONG THE LENGTH, USE
PLIERS TO PULL THE STAPLES, LIFT THE RAILS OUT. DO NOT USE A KNIFE
TO CUT THE BOX OPEN.
7/16” wrench or socket
#2 Phillips screwdriver
Tape measure
Utility Knife
2
STEP 1: REMOVE FROM PACKAGING AND REVIEW CONTENTS
A complete unit will consist of one canister box (marked box 1 of 2) and one rail box (marked box 2 of 2). Remove
the Top Cover, Canister, Clamp pack, hardware pack, and drain tubes from the canister box. Remove the rails from
the rail box (see caution below). Perform a quick inventory of the packaging contents to insure all parts are there.
TOOLS REQUIRED FOR ASSEMBLY:
BEFORE YOU START:
CAUTION! CAUTION!
Side Cut or Needle Nose Pliers
J
a
c
k
R
a
b
b
i
t
8
0
0
-
3
3
8
-
3
6
9
7
J
a
c
k
R
a
b
b
i
t
8
0
0
-
3
3
8
-
3
6
9
7
Page view 1
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments