STEP 5: INSTALLING CLAMPS & SHIMS (CONTINUED)
Clamp Shim
Bracket
Adjusting
Bolt
Plastic
Shims
FIG. 5A
FIG. 5B
For models with a fl ush-sided box such as StepSide trucks or Utility box, attach rails using TR1010 clamp and
self-tapping screw front and rear on rail in Figure 5D.
You will still need to shim the rails as shown in Figure 5A.
When installing the clamp, compress the rail and foam. Pull the clamp downward as tight as possible.
You may need to give the clamp and rail a twist as you tighten the screw all the way down to ensure the rail stays
level with side of the truck bed. See the video on our website for more detail.
FIG. 5D
Rail
Inner Bed
Wall
Self-tapping
screw
TR1010 fl ush
mount clamp
INSTALLATION INSTRUCTIONS
5
The electronics box has been pre-mounted to the inside of the canister.
Connect the battery wire harness into the 2-wire plug at the end of the canister (also
connect the optional manual switch harness, if installed at this time)
Attach the Red (positive) and Black (negative) wires to the battery or the truck manufacturers
suggested connection points at this time.
Unit is now ready to operate.
Press the Open button to open cover and press the Close button to shut the cover.
2-BUTTON REMOTE
KEY FOB x 2
Outside of
Truck Bed
Inside of
Truck Bed
Clamp Bolt
(tighten for
proper fi t)
Clamp
Rail Grip
Rail
FIG. 5C
STEP 7: CONNECTING THE ELECTRONICS
HARDWARE USED:
Locate the sweep seals (rubber weather strips) on the rails.
Apply Pace Edwards’ UV Protectant (or 303 brand protectant)
to a rag and wipe the underside of the sweep seal and the top
of the wear strip.
Extend the cover to the tailgate. Use an Allen wrench if needed
to carefully draw out the sweep seal (seal should be angled
outwards toward the cover – not rolled in toward the bed rail).
(Fig. 6A)
Proper care and placement of the sweep seal will ensure
smooth operation of the cover. Alcohol, petroleum based or
silicon-based cleaners such as Armor-All
®
should be avoided
and ARE NOT recommended for our covers
STEP 6: LUBRICATING & PLACING THE SWEEP SEALS
RIBBED BLANKET
SWEEP SEAL
WEAR STRIP
RAIL
FIG.6A
Clamp Bolt
(tighten for
proper fi t)
Clamp
Rail Grip
Rail
Inside of
Truck Bed
Alternate Style
Clamp for certain
truck applications
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals